Bergfalke
Using pliers, carefully make a 90 degree bend down
at the mark made. Cut off the excess wire, leaving
about 6mm beyond the blend.
Insert the 90 degree bend down through the hole in
the servo arm. Install one nylon snap keeper over the
wire to secure it to the servo arm.
Rudder servo
Rudder pushrod
Bend
and cut.
Snap keeper
Flaslink
Pushrod wire
Servo arm
1)
Elevator install as same as the way of aileron.
2)
Draw a center line onto the horizontal stabilizer.
Then put the horizontal into the fuselage.
With the horizontal stabilizer correctly aligned, Screw
the elevator in position.
Secure
3)
Check the fit of the horizontal stabilizer in its slot.
Make sure the horizontal stabilizer is square and
centered to the fuselage by taking measurements, but
don’t glue anything yet.
Elevator and Main wing must be aligned parallel
to each other
6
