Installing the aileron linkages
Installing the aileron linkages as pictures below.
100mm
Snap keeper.
M2
lock nut
Flaslink
Pushrod wire
Control horn
Bend and cut.
Silicone Tube
Bergfalke
Using pliers, carefully make a 90 degree bend down
at the mark made. Cut off the excess wire, leaving
about 6mm beyond the blend.
Insert the 90 degree bend down through the hole in
the control horn. Install one nylon snap keeper over
the wire to secure it to the control horn. Install the
control horn retaining screw and remove the from the
aileron.
Repeat the procedure to install the second aileron
linkages in the opposite wing half.
After both linkages are completed. connect both of
the aileron servo loads using a Y-harness you have
purchased.
Installing Electric Spoilers.
Installing the
as pictures below.
Electric Spoilers
Repeat the procedure to install the second
in the opposite wing half.
Electric
Spoilers
Motoreinbau / Motor Installation
4
Not included
