3 Commissioning
Please make sure that all requirements who are listed within the chapter
“System requirements” are met. Afterwards you can connect to the
device and then access the web server of it.
Important:
This chapter describers the factory defaults of the device. Via the web
interface you can configure the single interfaces individually, so an
access to the web interface is also possible via another interface.
3.1 Connect to the device
Before you can start to configure and later use your device you have to
access it first. For the S5/S7-TimeServer the three LAN ports as well as
the WLAN network which is offered from the device by default are a
common interface.
When you want to access your device via WLAN you first have to make
sure that the WLAN interface of your laptop or tablet is enabled. Then
you should open the list with available WLAN networks. There you
should now see a WLAN network with the SSID “RUT955_****”. The
exact SSID as well as the needed password can be found on the labeling
on the bottom of the device.
If you want to access the device through one of the LAN ports, you only
have to connect your computer and the device with a cable.
As soon as you are connected with the device via WLAN or LAN you
have to check and maybe adjust your IP configuration. The device is
configured that a DHCP server is running on this interface. If your device,
which should be connected with the S5/S7-TimeServer, is set up that it
requests an IP address via DHCP automatically no further action is
required. Otherwise you have to enable DHCP on your device or
alternatively assign an address between 192.168.1.2 and 192.168.1.254
manually.
page
7
manual S5/S7-TimeServer V1.00
