5 Installation
PL0xx/PDxxx Piezo Actuator
PZ265E
Version: 1.0.0
25
INFORMATION
The electrode marking is shown in the product view (p. 10).
Use a red stranded wire for the voltage connection (+).
Use a black stranded wire for ground (-).
Requirements
You have read and understood the general notes on installation (p. 17).
The PL0xx/PDxxx is discharged (p. 40) and short-circuited (p. 41).
You have read and understood the user information of the manufacturer of the
adhesive.
Tools and accessories
Suitable stranded wires that meet the applicable standards for the conditions of use
Electrically conductive, silver-filled epoxy resin adhesive
Suitable cable tools
Gluing stranded wires to a piezo actuator (only models without stranded wires)
1.
If necessary, clean the bonding surfaces so that they are dry, dust-free and grease-free.
2.
Remove the insulation at the end of the stranded wire to be glued and shorten the
stripped end to a length of 2 mm.
3.
Glue the untwisted stranded wire on the electrode so that the glue does not flow
beyond the adhesive point at any time:
a)
Apply the thinnest possible layer of adhesive to the adhesive point provided on the
electrode.
b)
Apply a small amount of adhesive to the stripped end of the stranded wire.
c)
Hold the stranded wire in the desired orientation on the adhesive point and fix the
stranded wire.
4.
Repeat steps 2 and 3 for the second stranded wire.
5.
Wait until the adhesive has completely hardened.