✓
The L-505.01A200F is not connected to the electronics.
✓
You have prepared the load so that it can be affixed to the mounting holes on the motion
platform:
■
The distance between the center of gravity of the load and the center of the motion
platform is as small as possible in all directions.
■
At least three points are provided for affixing the load on the motion platform.
NOTICE
Impermissibly high load on the L-505.01A200F
An impermissibly high load impairs the motion of the motion platform and can damage the
L-505.01A200F.
►
Pay attention to the
maximum permissible forces (p. 32)
that may act on the motion
platform.
►
In the case of multi-axis systems, include the masses of the positioners to be moved
when calculating the load.
NOTICE
Excessively long screws and locating pins
Screws and locating pins that are inserted too deeply can damage the L-505.01A200F.
►
Pay attention to the
depth of the mounting and locating holes (p. 36)
.
►
Only use screws and locating pins of the correct length for the respective mounting holes.
Affixing the Load
1. If necessary: Insert the locating pins into the corresponding holes in the motion platform.
2. Align the load on the motion platform so that the mounting holes selected in the motion
platform can be used for mounting the load.
3. Place the load onto the motion platform so that the locating pins are inserted into the
corresponding locating holes in the load.
4. Tighten the screws in all mounting holes.
5. Check that the load is affixed firmly to the motion platform.
6.6
Connecting the L-505.01A200F
NOTICE
Damage due to mechanical stress on the cable!
The cable will break from excessive or repeated bending. A broken cable will lead to failure
of the L-505.01A200F or damage to the L-505.01A200F or the electronics.
►
Install the L-505.01A200F so that the cable has a bending radius of
≥
35 mm.
►
If necessary: Use cables that are approved for recurring mechanical loading (e.g., drag
chain cables).
Tools and Accessories
■
If necessary: Suitable screwdriver for the locking screws of the connectors.
Requirements
✓
You have read and understood the
general safety instructions (p. 8)
.
✓
You have read and understood the user manual for the electronics used.
✓
You have installed the electronics properly.
✓
The electronics are switched off.
6 INSTALLATION
L505M0011EN
‒
10/22/2018
22
M O T I O N | P O S I T I O N I N G
