Photron FASTCAM SA7, Руководство по оборудованию

Страница: 64 / 87

Chapter. 4 Connecting a PC
50
4.1.4. Connecting Multiple Systems and a PC
With PFV, the system’s control software, one PC can connect to and control multiple FASTCAM
SA5,FASTCAM SA4 ,FASTCAM 2 ,FASTCAM 1.1, FASTCAM SA7,FASTCAM SA8, FASTCAM
APX-RS, and FASTCAM MH4-10K systems.

When connecting to multiple systems, set the IP address of each one to a unique setting.
4.1.5. Gigabit Ethernet Interface Initialization
When encounter problems on communication between the control software PFV and the camera,
please perform the following steps to initialize the Gigabit Ethernet interface.
1. Press and hold on the USER SW (Programmable Switch) on the rare of camera for about
10~15 seconds.
2. When the LEDs blink from left to right and then from right to left alternately, it indicates the
initialization operation is accomplished.

Pressing and holding on the USER SW (Programmable Switch) for more than 15 seconds will result
in an IP Address Initialization.
4.1.6. Camera IP Address Initialization
In some circumstance when the IP address is changed, and the new IP address is not explicit, an IP
Address Initialization operation is recommended. In this case, the IP address will be reset to
192.168.0.10 as the factory settings.
1. Press and hold on the USER SW (Programmable Switch) on the rare of camera for over 15
seconds.
2. When the LEDs blink from left to right and then from right to left alternately, it indicates the
initialization operation is accomplished.