Photron FASTCAM Multi, Руководство по оборудованию

Страница: 38 / 81

Chapter 3 System Connections
24
3.4.4. Initializing Gigabit Ethernet Interface and Camera IP Address
You could reset the IP address back to the factory setting (192.168.0.10) by going through below
steps. This could be useful at times when you could not connect to the camera while running PFV,
the product
’s control software, or when you accidentally changed your camera’s IP address and lost
it.
1. Out of 4 programmable switches (USER SW) on the front panel, hold either USER1 or USER
4 for at least 10 seconds.
2. Front panel
’s LEDs will be turned on in sequence from left to right then right to left, which
means initialization of Gigabit Ethernet Interface and Camera
’s IP address has been
successful.

Holding the programmable switch (USER SW) for more than 15 seconds will execute initialization
to factory default settings.
3.4.5. Initializing to Factory Default Settings
Below operation will reset the camera to the factory default settings.
1. Out of 4 programmable switches (USER SW) on the front panel, hold either USER1 or
USER4 for at least
15 seconds .
2. Front panel
’s LEDs will be turned on in sequence from left to right then right to left, which
means initialization of Gigabit Ethernet Interface and Camera
’s IP address has been
successful.

For the firmwares before Ver.2.00, holding USER1 or USER4 switches for more than 10 seconds
will initialize Gigabit Ethernet Interface, holding USER1 or USER4 for more than 15 seconds will
initialize camera
’s IP address.