Photometrics Evolve 512, Руководство пользователя

Страница: 19 / 48

Evolve 512 Users Manual 7
Installing the
FireWire
Interface Card
You will be using an Evolve FireWire interface card to allow the camera to communicate
with your computer.
Before installing the interface card, refer to the ‘Release Notes’ files on the CD-ROM and to
the Software Installation insert. The insert instructions will step you through the FireWire
interface card installation.
After installing the interface card, continue to
Connecting Your Evolve 512 Camera .
Connecting Your
Evolve 512
Camera
The following connectors are located on the back of the Evolve 512 camera:

DATA connector: Type 1, 6-pin IEEE-1394a (FireWire) connector for data transfer

POWER connector: 25-pin, Dsub connector for camera power (see POWER
Connector Pinout section in Chapter 5 for details)

Power switch: Turns the camera on and off.
The following connector is located on the power supply of the Evolve 512 camera:

I/O connector: Hirose HR10A-10R-10S, 10-pin connector for input/output
control signals (see I/O Connector Pinout later in this manual)
To connect your
Evolve 512
camera
1. Connect the straight end of the DATA cable to the Evolve FireWire interface card
that you have installed in the host computer. The DATA cable (shown below)
connects your Evolve 512 camera to the Evolve FireWire interface card. This
interface cable is identifiable by its 6-pin connectors. It is designed to serve as a
conduit for data.
Figure 3. DATA Cable