17
EN
09302
6. SLEEP MODE (AUTO POWER-OFF FUNCTION)
If the vehicle is not used for 7 consecutive days, the system enters SLEEP MODE and will not detect either the high-
frequency signal from the radio remote control or the activation of the SHOCK SENSOR.
To restore normal system functionality:
- if the alarm was disarmed, simply turn on the ignition.
- if the alarm was armed, it is necessary to turn on the ignition and press button 2 (DISARMING) on the radio
remote control.
If the remote control is not available, it is possible to disarm the alarm using the PIN code for emergency
disarming. (see next paragraph)
7. EMERGENCY DISARMING WITH PIN CODE
This procedure allows the alarm to be disarmed, using the vehicle key if the radio remote control is not available
because it is lost or damaged.
The PIN code set is: 1, 2, 3, 4.
Each ignition OFF/ignition ON sequence corresponds to 1.
To enter the code the sequence must be repeated for the number of times corresponding to the number that must
be entered. Confirm by keeping the ignition ON for 5 seconds.
For example, to enter the number 3:
ignition OFF/ignition ON,
ignition OFF/ignition ON,
ignition OFF/ignition ON 5 seconds.
Proceed in this way to enter all four numbers. After entering the last digit the siren will emit two beeps and the
alarm will be disarmed.
Changing the PIN CODE
Turn on the ignition and press and hold button 4 (TRACKING/PANIC ALARM) for 5 seconds, the siren will emit
a long Beep to confirm that the "PIN setting" mode is active. Once the new 4-digit code (from 1 to 9) has been
decided, and with the ignition ON, start entering the numbers. Considering that each OFF /ON ignition sequence
corresponds to 1, in order to insert to enter the code, repeat the sequence for the number of times corresponding
to the number you wish to enter and confirm by keeping the ignition ON for 5 seconds.
Example: for entering number 3
ignition OFF/ignition ON,
ignition OFF/ignition ON,
ignition OFF/ignition ON 5 seconds.
Do the same for all 4 digits, at the end of the procedure the siren will beep twice to confirm that the code has been
entered correctly.
8. GARAGE MODE (SERVICE MODE)
This function makes it possible to deactivate both the user recognition and the anti-theft function
(e.g. for vehicle maintenance).
- switch the ignition on
- press button 2 (DISARMING) on the radio remote control: the siren will sound once to confirm that the
GARAGE MODE is active.
In this mode, every time the ignition is switched off, the siren will sound 4 times.
