Phonic ICON 300, Руководство пользователя

Страница: 8 / 14

8 ICON 300/700
Bridge Mono Configuration for Direct Outputs
1. Set into bridge mode
2. Connect the signal to channel 1's input
only. Do not connect an input signal to
channel 2.
3. Use on channel 1's gain control to set the
level. Both channels' signal and clip indicators
should flash identically when the amplifier is
operating.
Audio Transformer Outputs
Make sure the sum of the power settings of all
the speakers does not exceed the power rating of
the amplifier. It is a good practice to allow a 20%
safety margin. For example, if the amplifier has a
power rating of 300W, it is always a good idea to
make sure the sum of the loudspeaker loads on the
distributed line is 240W or less.
25 volt line output connection
50 volt line output connection
100 volt line output connection
Bridge Mono Configuration for Audio
Transformer Outputs
1. For driving 140V or 200V distributed lines, the
amplifier must be set into bridge mono mode.
2. Connect the signal to channel 1's input
only. Do not connect an input signal to
channel 2.
3. Use only channel 1's gain control to set the
level. Both channels signal and clip indicators
should flash identically when the amplifier is
operating.
140 volt line output connection,
bridge mono mode
200 volt line output connection,
bridge mono mode