Phonic CELEUS 400, Руководство пользователя

Страница: 10 / 32

6
CELEUS 600
English
39. AUX RTN Controls
This control adjusts the signal level of audio fed through to the
stereo AUX Return inputs, which will be added to the main mix.
The “To AUX 1” control adjusts the post-fader level of the signal
from the AUX Return control to the AUX 1 mix (also known as
"EFX to Monitor").
40. EFX RTN Controls
This control adjusts the signal level of audio fed through to stereo
AUX Return 2 inputs. If no device is plugged into the AUX Return
2 inputs, this control then acts as the final level control of the built-
in Digital Effect Engine. The signal of this control is sent to the
appropriate mix, as selected by the Main L-R / Group 1-2 button.
41. Main L/R - Group 1/2 Button
This button changes the destination of the signal sent from the
AUX Return 1 through to AUX Return 3 mixing buses between the
Main L/R and Group 1/2 mixing buses.
42. AUX Send Master Controls
These controls adjust the final level of the AUX mixes (as
taken from the AUX level controls on each channel strip), the
audio of which is sent to corresponding AUX send outputs. The
corresponding SOLO button allows you to send the AUX Send
signal to the Control Room / Phones mix.
Digital Effect Processor
32. Program Control
This control will allow users
to select one of the 16 built-in
digital effects of the CELEUS.
The effect names that
correspond with the numbers
can be found on the top of the
mixer’s face, or in the digital
effect table.
33. Effects On Button & LED
Pushing this button will turn the
built-in effect processor on and
off. When the effect processor
is activated, the corresponding
LED will light up to indicate so.
34. Parameter Control
Turning this control will adjust
the one main parameter of the
selected effect. Each effect’s
parameter can be found on the
digital effect table.
Master Section
35. +48V Indicator
This LED indicator will light
up when Phantom Power
is activated on microphone
inputs.
36. Power Indicator
This LED indicator illuminates
when power of your CELEUS
600 mixer is activated.
37. Level Meter
These dual 11-segment level meters give an accurate indication
of when audio levels of the Main L/R output signals reach certain
levels. The 0 dB indicator illuminates is approximately equal to an
output level of +4 dBu, and the PEAK indicator illuminates about 6
dB before the signal is dynamically clipped. It is suggested for the
maximum use of audio to set the various levels controls so that it
sits steadily between 0 and 8 dB to make full use of audio, while
still maintaining fantastic clarity.
When any of the solo buttons are pushed in, the level meter will
then display the audio properties of the Control Room / Phones
mix. This is especially helpful when setting the levels of each
individual channel, as is shown in the Channel Setup section of
this manual. The “Solo” LED will illuminate when the Level Meter
displays the audio properties of the Control Room / Phones signal.
38. Main Faders
These faders are the final level controls for the Main Left and Right
mixes sent to the Main outputs on the rear. When pushed all the
way up, the Main L/R fader provides 10 dB of gain to the signal,
and when set all the way down, the signal is effectively muted.
These faders also adjust the final output level of the signal sent
through the USB interface to the computer.
32
33
34
35
36
37
38
46
41
44
45
40
39
42
43
47
48