OK
X
?
R
P
tuv
9
wxyz
7
pqrs
0
j
mno
4
gh
2
abc
3
def
1
is marked with the following symbol
. Take the jack pin at the end of the cable on
the power adaptor provided and place it in the power input socket. Take the power
adaptor and connect it to your power socket on the wall.
Install batteries into handset (it is recommended to replace batteries every 2
nd
year).
3.
The connection for the phone line is
located on the underside of the base
station and is marked with the following
symbol
. Connect one end of the
telephone line to this socket on the
base station and the other end to the
telephone outlet socket on the wall.
Connecting base station to power socket.
The connection for power input is located
on the underside of the base station and
1.
2.
Charging handset.
When batteries are charged and installed correctly the base unit illuminates to show
charging in progress. (see base uni
t
/
-
+
)
NOTE
: The LED light on base shows the charge status (steady light) and in-use (flashing). The LED
will also keep flashing when the base is in registration mode (refer to Advance Operation Section).
(Please refer to Appendix A for desktop installation and Appendix B for wall installation).
4.
I MPORTANT NOTICE: To obtain best battery performance, keep the
handset on charged for 15 hours when first installed.
1
2
3
3
4
a. Remove the battery compartment door.
b. Insert the two rechargeable batteries while observing the symbol for
polarity marked on the phone.
polarity symbol
7
Xen Setup
g