Xen Advanced Option
X
R
P
r
a
H
K
A
H
A
o
h
u
3
4
Preparation for Registration/Subscription Procedures
Make sure the additional handset is installed with charged batteries.
Before you proceed, you should have the following information available:
i.
Make sure the handset you intend to register is DECT system and GAP compatible.
ii.
Information showing how to bring the handset into registration mode and registration
procedures. Usually, this information can be found in the instruction manual that comes
with the handset.
iii.
The PIN code of the base station. PIN code of base unit may be changed by the user. If
you have changed the PIN code yourself, you must have this PIN code available . If you
have not changed the PIN code yourself, the default base PIN code of this DECT phone is
0000.
Registration Procedure
Base unit
Make sure no other handset is in charging mode and LED of the base unit is not ON at this
point.
Bring the base unit into registration mode. Press and hold the Page button on the base
unit for around 10 seconds until the LED starts to blink, then release the button.
NOTE
:
The base unit will remain in registration mode for 1 minute. You must complete the rest of the
procedures before the base unit exits the registration mode. If you fail to complete the registration in
time, the indicator on the base unit will stop blinking and you must restart the entire procedures again.
Handset Registration Procedure
If you intend to register an additional handset different from a Xen, you should follow
the instructions that come with the handset you have purchased to finish the registration
procedures.
If you intend to register an additional Xen handset, you should follow the instructions listed below.
Key Map:
and follow instructions on next page
You should select the first available base (BASE 1). Use the digit key pad to enter "1".
The handset starts to search for any available base in registration mode within range. When
found, the handset screen may show a long series of numbers. This is the identity number of
the base unit. Press
button to confirm.
1.
2.
1.
2.
22