Phonic Ear FrontRow Pro, Руководство по установке

Страница: 18 / 33

15
Step 3:
Routing speaker and sensor cables
Estimated time for this step: 45 minutes
With your receiver installed, you now have a base for routing your cables.
Ceiling speakers
If you’re installing ceiling speakers, follow the guide-
lines below. (If you’re installing wall speakers, follow
the instructions starting on page 17).
1. Remove selected ceiling tiles
Remove the ceiling tiles you marked in Step 1
Remove the ceiling tiles directly above the sensor
locations you marked in
Step 1
Remove the ceiling tile directly above the receiver
you mounted in
Step 2
2. Prepare and route cable
Tie an object, such as a roll of electrical tape, to
some twine to use as a pull line. This will help you
more accurately direct the cable in the area above
the ceiling.
Standing on a ladder with your head and shoulders
in the space where you’ll install a ceiling speaker,
toss the weighted end of your twine through ceiling
space into the open tile hole above your receiver.
Connect the other end of the twine to the speaker
cable. Pull cable through to the receiver.
Your goal is to have the cable entirely above the ceil-
ing, with only the two ends protruding from the
open space above the receiver and your chosen
speaker tile.
Repeat these steps for the other three speakers and
for your sensors
Tip
Can’t get the pull line to the receiver in one throw?
Get the weighted end of the pull line as close to the receiver as you can. Then
move your ladder under the tile where your cable stopped, remove that tile, and
repeat until you’ve hit the mark.
FrontRowProInstallerGuide.qxd 6/10/05 4:01 PM Page 21