Speaker output ZONE 1 is supplied from the internal power output
stage. The output is 100V with the maximum power of 200 watts.
Drawing: YELLOW=100V, BLACK=COM
A direct loudspeaker output is supplied from the internal power
output stage. The output is 100V with the maximum power of
200 watts. Drawing: BLUE=100V, BLACK=COM.
Please note that the ZONE-1 output and the direct loudspeaker
output are supplied from the same power output stage. The
connected load at ZONE 1 and the direct output should not exceed
more than 200 watts.
Instruction manual
- 9 -
PV-5D.2-2U
™
7. SPEAKER OUTPUTS
The 100V-speakers are connected to the terminal 100V and COM-Pin.
Low-impedance loudspeakers with an impedance of 8 or 4 ohms are connected to the 8 ohm terminals or
4 ohms and COM. Fig. 1 shows the speaker output terminal with Zone-OUT-1.
Attention:
Only 100V speakers OR low impedance speakers can be connected -
simultaneous use is not possible.
© Copyright 2019, Phoenix Professional Audio GmbH, www.phoenix-pa.com
Phoenix logo is registered with the DE Patent and Trademark Office (TM)
All trademarks are the property of their respective owners
Unbalanced inputs: Strip the wire conductors by 6 mm and
connect them to the terminals as shown. The center pin
must be connected to the shielding pin as shown. Tighten
the screws.
1 GND
2 +IN
3 -IN
1 GND und wire bridge to 3
2 +IN
Balanced inputs: Strip the wire conductors by 6 mm
and connect them to the terminals as shown. Tighten
the screws.
(Fig. 1)
REAR SIDE / CONNECTIONS
1
7
9
6
10
3
2
5
8
4
