Phoenix 4400- DHP
November 2017
16
15. Rear Power Panel
1. Main power ON/OFF switch
2. Safety fuses are located on the Rear Power Panel.
a. Hot Fuse - protects the heaters
b. Motor fuse - protects the drive motor
NOTE: Be sure to replace blown fuses with the proper rated
3. Cooling Fans switch
16. Safety Shield and Safety Photo Eye
1.
Insert left side with spring pin into support block of the shield.
2.
Insert right side with spring pin into support block of the shield
3.
Lower safety shield onto side support bar.
4.
When mounting, remove the shield.
5.
The safety photo eye, located just before the heat rollers, will protect the operator from becoming
entrapped in the rollers. If the eye becomes blocked, the motor will shut off stopping the rollers.
To reset the motor, remove the blockage and press MOTOR.
6.
Use the foot pedal to laminate and mount boards.
Warning: Ensure the
safety shield is in place before operating the laminator.
Operating without the safety shield can cause serious injury.
Support block
Support bar
Front Safety Shield
Safety photo eye
2 a.
2 b.
3
1
