DUOMAT 7
Notices for Operation
43170 6.0
29
7.2.2
Optional mechanical reset option
Figure 15
Back side of the DUOMAT 7, with mechanical reset function
A
Lever for operating the mechanical reset
function (on back section)
B
Label for mechanical reset function
C
Lever for operating the mechanical reset
function (on leg section)
CAUTION
The mechanical reset function is not a safety system and does not avert danger. It
should not be used to adjust the bed in emergencies!
If you have purchased the DUOMAT 7 with the mechanical reset function, then you should note the
following:
The mechanical reset function allows you to lower the back and leg sections of the bed in the
event of a power outage.
Take note of the information on the label located on the back of the double drive (refer to Figure
15).
Take the load off the leg and back sections by lifting up on them.
The mechanical reset is carried out by pushing on one of the levers. This allows the unencum-
bered leg or back section to recline. Continue to press on the lever until the back or leg section
is completely lowered.
Depending on the model, it may be possible for the leg or back sections to be lowered by gravi-
ty. If the leg or back sections do not fall down from their own weight, then you should apply gen-
tle pressure to the end product to help it lower.
After the mechanical reset function has been carried out, the clutch will engage automatically
when the drive system is moved back into position. The drive system is then ready.
NOTICE
If you are installing the DUOMAT 7 with a mechanical reset function in your end prod-
uct, then it is essential that you use mechanical end stops to limit the bottom end point
motion. Mechanical damage to the drive system will result if end stops are not used.
A
C
B
