Installation
DUOMAT 7
26
43170 6.0
6.2.3
Dismantling
CAUTION
Work on electrical components should be carried out only when the mains power and
battery plugs (when present) are unplugged.
Certain details may change as a result of technical changes.
1
Move your product into a position where it is supporting no load.
CAUTION
Be sure to carry out work on the drive in a position so that no loads are bearing on it.
Only in this way can you be sure to avoid any risks or crushing or injury.
2
Unplug the mains power plug and the battery plug (when present)!
3
Remove the screws on the shield cover and take off the shield cover (if present).
4
Disconnect all additional components such as slave drives, handset or battery from their sock-
ets.
NOTICE
Be sure to support the drive's weight while you open the shutters to release it.
5
Pull out strongly on the shutters. (The optional locking device must first be opened before open-
ing the shutters.)
6
Pull out the DUOMAT 7 far enough so that the brackets are out of the slots. The DUOMAT 7 is
now unattached and can be removed.
7
Push the shutters back onto the DUOMAT 7 so that they are not lost during transportation.
