Phoenix Contact THERMOMARK ROLL 2.0, Руководство пользователя

Страница: 33 / 54

Mounting accessories
108716_en_01 PHOENIX CONTACT
33 / 52
Removing the blades
Figure 4-4 Removing the blades
• Rotate the shaft (1) clockwise using a TX10 Torx screwdriver until the gear racks (2) are
disengaged.
• Pull the upper blade (3) out of the guides.
• Remove the lower blade (4).
• Remove any deposits on the blades using a cloth dampened with label remover.
• Push the lower blade into the holders from above.
• If necessary, place the springs (5) back in the spring pockets.
• To insert the upper blade, push the lower blade onto the panel. Place the upper blade
in the guide. Push it upwards until the gear racks engage with the gear wheels.
• Rotate the shaft using the Torx screwdriver until the blade reaches the upper stop.
1
3
4
5
2
WARNING: Danger of cutting
The cutter blades are sharp.