QUINT4-PS/12-24DC/24DC/1.3/SC
110257_en_00
PHOENIX CONTACT
16/32
6.3.1 Performing high-voltage testing
If high-voltage testing of the control cabinet or the power
supply as a stand-alone component is planned during final
inspection and testing, the following features must be
observed.
– The power supply wiring must be implemented as
shown in the wiring diagram.
– The maximum permissible test voltages must not be
exceeded.
Avoid unnecessary loading or damage to the power supply
due to excessive test voltages.
Figure 1
Potential-related wiring for the high-voltage
test
Key
For the relevant applicable test voltages and
insulation distances, refer to the corresponding
table (see technical data: electric strength of the
insulation section).
No. Designation
Color coding
Potential lev
-
els
1
DC output circuit Blue
Potential 1
2
Signal contacts Blue
Potential 1
3
High-voltage
tester
--
--
4
DC input circuit Red
Potential 2
Input DC
Boost >100%
> 75%
> 50%
DC OK
Signal (SIG)
1.1 1.2
Output DC
SIG
+
̐
QUINT PO
WER
O
rd.No
.xxxxxxx
3.1 2.1 2.2
+
̐
U
Out
P
Out
>
P
Thr
HV
/=
1
2
3
4
ô