Phoenix Contact 1005869, Руководство пользователя

Страница: 18 / 52

FL EPA 2
18 / 50
PHOENIX CONTACT 108452_en_01
4.0.4 Easy Config modes
Modes 5 to 9 are used for defining the operating mode of the network (WLAN/Bluetooth,
with or without optimization for PROFINET operation). Set the device, which will later act as
an access point/NAP, to the desired mode.
Configure the clients for mode 4. The access point or NAP then configures the devices in
mode 4, matching the selected operating mode. As soon as a device is configured as a
client, the device is restarted.
The access point scans for configurable devices for 120 s (the scan can be canceled by
switching it off and on). The device is then also restarted. The connection is established
automatically.
Table 4-1 Indication of received signal strength via the A-B-C-D LEDs
Mode Role Description A B C D
1 Bluetooth
PANU
Configure the device as a Bluetooth client,
then discover devices in mode 4 and config-
ure them accordingly as a client
2 --- Reset configuration to factory defaults
3 --- Reset IP settings to factory defaults
4 Client Wait for discovery and configuration
5 WLAN AP
Configure the device as an access point, then
discover devices in mode 4 and configure
them accordingly as clients
6 Bluetooth
NAP
7 WLAN AP
with PROF-
INET optimi-
zation
8 Bluetooth
NAP with
PROFINET
optimization
9 Bluetooth
PANU with
PROFINET
optimization
10 Add PROF-
INET optimi-
zation only
11 Safety: dis-
able configu-
ration inter-
faces only
If a configuration exists, switch off all configu-
ration interfaces for safety-based communi-
cation.