Philips UrbanSpark, Инструкция по монтажу, Страница: 5 / 13

4
Pole and base plate Assembly
(Applicable for both 4m and 6m)
1. Rest the pole over two resting blocks as
shown.
2. Assemble the base plate using 8 Nos M10 screw with
M10 washer, M10 nut and M10 check nut.
Note: Recommended size of resting
block (Not part of supply).
250
400
250
Hard Block
Soft
cushioning
250
400
250
Hard Block
Soft
cushioning
M10 Screw
M10 Washers (2x)
M10 Nut
M10 Lock Nut
M10 Screw
M10 Washers (2x)
M10 Nut
M10 Lock Nut
3.Open the service hatch door using the
T30 6 Lobe pin drive key provided along
with the PV Cartridge.
5
4m Pole Assembly
1.Insert the PV cartridge to the pole as
shown. Pass the cartridge cable through
the cutout provided and then pull the
same using steel rope from service
hatch.
Warni ng: Wire should be pulled
out properly, don
’t let the wire to
come between mating faces.
5