Philips UrbanSpark, Инструкция по монтажу, Страница: 13 / 13

Battery replacement
1. Open the
service
hatch.
2. Follow the disconnection
sequence (refer page 2) to
disconnect the charge
controller and take out the
charge controller 3. take the old
battery out and
replace a new
one. 4. Affix controller
Notice: Turn on/Turn off delay time is about 5
minutes.
LE
D 2
LE
D 1
3. FIRSTLY, connect luminaire
to the controller.
4. SECONDLY, connect
battery to the controller.
7. Check controller indicator
lighting status
(The Indicators quantity are
different depend on different
controller).
8. Close the service door after
completion of all the activities.
Connection Note:-
1.Configure the charge controller as per customer requirement. For more details contact Signify Local sales/
Service representative.
2.Positive and negative connectors of PV panel and battery are properly connected with charge controller.
Don
’t connect the battery positive to PV panel positive and vice versa.
Indicators
LED Blinking 1 Sec ON/off Green/Orange (As per design) Normal Charging
LED Blinking 0.5 Sec ON/off Green/Orange (As per design) Battery Recovery (LFP)
Battery
Charging
Description
2 LEDs Battery Discharging/LED Load ON
Battery Deep Discharge cut off
Any other fault in system
Red LED ON for 800mSec and Off for 5 Sec
Both LED Green/Orange & Red blinking @ 1 sec rate
Status
No Indication
5. THIRDLY, connect PV Panel
to the controller.
6. FOURTHLY, Connect
Bluetooth low energy module
with RS485 cable.
13