8
Philips · Screeneo U4
4 Connect the power cable to an electrical
socket.
• The power LED on the projector lights
up in red.
d
c
a
b
Prepare the remote control
CAUTION!
The improper use of batteries can
lead to overheating, explosion, risk of
fire and injury. Leaking batteries can
possibly damage the remote control.
Never expose the remote control to
direct sunlight.
Avoid deforming, dismantling or
charging the batteries.
Avoid exposure to open fire and water.
Replace empty batteries immediately.
Remove the batteries from the remote
control if not in use for long periods of
time.
1
Open the battery compartment.
2 Insert the supplied batteries (type AAA)
with correct polarity (+/-) indicated.
3 Close the battery compartment.
•
When using a remote control with infrared
signals, point the remote control at the IR
sensor on the projector, and make sure
there is no obstacle between the remote
control and the IR sensor.
Power on and set up the
projector
Power on/off the projector
•
To turn on the projector, press and hold
on the projector for 2 seconds or press
on the remote control. The power LED on
the projector turns from red to white.
•
To turn off the projector, press and hold
on the projector/remote control for 2
seconds or press this button twice. The
projector enters standby mode and its
power LED turns from white to red.
•
To fully shut down the projector, disconnect
the power cable from the electrical socket.
Set up the projector system
When you turn on the projector for the first
time or after it was reset to its factory default
settings, the projector system will start and
prompt you to set it up by making some basic
settings.
After the setup, you can start using the projector
or continue to make other adjustments.
Step 1
:
Select the display language
Press the down or up navigation button on the
remote control to select your preferred display
language and press the
OK
button to confirm.
Note
: The default display language is
English
and not all languages are available.
Step 2
:
Adjust the projector's position
Adjust the projector's position to get the
optimal screen shape and size.
When you are done, press the
OK
button.
Step 3
:
Set the date and time
Press the down or up navigation button on
the remote control to set the values for the
date and time. Press the right or left navigation
button to move to the next or previous value.
When you are done, press the right navigation
button to select
Next
and press the
OK
button.
You will see the home screen shown below
after completing the setup.
