Cleaning and maintenance
Never use scouring pads, abrasive cleaning agents or aggressive liquids
such as petrol or acetone to clean the shaver, its accessories and the Jet
Clean System (RQ1275CC, RQ1258CC only).
The best and most hygienic way to clean the shaver is in the Jet
-
Clean System (RQ1275CC, RQ1258CC only). You can also rinse the
shaver under the tap or clean it with the cleaning brush supplied.
Be careful with hot water. Always check if the water is not too hot, to
-
prevent your hands from getting burnt.
Clean the shaver after every shave for optimal shaving performance.
-
You can clean the outside of the shaver with a damp cloth.
-
Regular cleaning guarantees better shaving performance.
-
Cleaning the shaving unit
Be careful with hot water. Always check if the water is not too hot, to
prevent your hands from getting burnt.
1
Rinse the shaving unit under a hot tap for some time.
2
Pull open the three shaving heads one by one.
3
Rinse all three shaving heads and all three hair chambers under a hot
tap for 30 seconds.
Note: You can also brush the shaving heads and hair chambers with the
cleaning brush supplied.
Be careful with hot water. Always check if the water is not too hot, to
prevent your hands from getting burnt.
4
Carefully shake off excess water and leave the shaving heads open to
let the shaving unit dry completely.
Never dry the shaving unit with a towel or tissue, as this may damage the
shaving heads.
Cleaning the shaving unit in the Jet Clean system (RQ1275CC,
RQ1258CC only)
The Jet Clean System:
C
F
- Type RQ1007 has one automatic cleaning program. When you
press the on/off button, the Jet Clean System starts cleaning in the
automatic cleaning program.
Preparing the Jet Clean system for use
Fill the cleaning chamber before fi rst use.
1
Put the small plug in the Jet Clean System.
2
Put the adapter in the wall socket.
The holder automatically moves to the highest position.
,
3
Simultaneously press the release buttons on both sides of the
cleaning chamber (1). Then lift the Jet Clean System off the cleaning
chamber (2).
The cleaning chamber remains behind.
,
4
Unscrew the cap from the bottle with HQ200 cleaning fl uid.
5
Fill the cleaning chamber with HQ200 cleaning fl uid to a level
between the two lines.
6
Place the Jet Clean System back onto the cleaning chamber.
Make sure the release buttons click back into place.
Using the Jet Clean system
Note: If you use the shaver with shaving foam or shaving gel, we advise you
to rinse it under the hot tap before you clean it in the Jet Clean System. This
guarantees an optimal lifetime for the cleaning fl uid.
1
Hold the shaver upside down above the holder with the back of the
shaver pointing towards the holder.
RQ1007
2
1
English
English
