Activating the travel lock
1
Press the on/off button for 3 seconds to enter the travel lock mode.
The lock symbol lights up on the display. After a few seconds it goes
,
out.
Deactivating the travel lock
1
Press the on/off button for 3 seconds.
The motor starts running to indicate that the travel lock has been
,
deactivated.
The shaver is now ready for use again.
Note: When you place the shaver in the plugged-in charger or Jet Clean System,
the travel lock is automatically deactivated.
Blocked shaving heads
Note: The displays of the various shaver types look different, but show the
same symbol.
- If the shaving heads are blocked, the shaving unit symbol, the tap
symbol and the exclamation mark fl ash. In this case, the motor cannot
run because the shaving heads are soiled or damaged.
When this happens, you have to clean the shaving unit or replace it.
-
The shaving unit symbol, the tap symbol and the exclamation mark
-
continue to fl ash until you unblock the shaving heads.
Charging
Charging takes approx. 1 hour.
RQ1275, RQ1275CC: A fully charged shaver has a shaving time of up to 60
minutes or 20 days.
RQ1258, RQ1258CC: A fully charged shaver has a shaving time of up to 50
minutes or 16 days.
Charge the shaver before you use it for the fi rst time and when the display
indicates that the battery is almost empty (see section ‘Battery low’ in
chapter ‘The display’).
Quick charge
After the shaver has charged for 5 minutes, it contains enough energy for
one shave.
Charging in the charger
1
Insert the small plug into the charger.
3 sec.
2
Unfold the charger (‘click’).
3
Put the adapter in the wall socket.
4
Put the shaver in the charger.
The display shows that the shaver is charging (see chapter ‘The
,
display’).
Charging in the Jet Clean system (RQ1275CC, RQ1258CC
only)
1
Put the small plug in the Jet Clean System.
2
Put the adapter in the wall socket.
3
Hold the shaver upside down above the holder with the back of the
shaver pointing towards the holder.
Note: The shaver cannot be placed in the Jet Clean System when the protection
cap is on the shaving unit.
4
Place the shaver body in the holder behind the two clips (1) and
press it down until it locks into place (2).
The display shows that the shaver is charging (see section ‘Charging’
,
in chapter ‘The display’).
Using the shaver
shaving
skin adaptation period
Your fi rst shaves may not bring you the result you expect and your skin
may even become slightly irritated. This is normal. Your skin and beard need
time to adapt to any new shaving system.
1
2
English
English
