8
simply
FLO
User Manual
Operating the simply
FLO
Device
1� Select a location that allows the concentrator to draw in room air
without being restricted� Make sure that the device is at least 15
to 30 cm away from walls, furniture, and especially curtains that
could impede adequate airflow to the device� Do not place the
device near any heat source�
2� After reading this entire manual, connect the output cable of the
AC Power Supply to the simply
FLO
power input connector�
3� Connect the AC Power Cord’s connector into the AC power
supply�
4� Connect the AC Power Cord’s plug into an AC outlet installed to
meet national or regional electrical code�
Note
: The AC Power Supply is equipped with a green light, which illuminates
when it is connected to an energized AC power source�
5� Connect a nasal cannula to the patient cannula connector on top
of the device� Ensure that the cannula is routed to prevent it from
being pinched or kinked to avoid a disruption of oxygen flow�
Note
: A standard single lumen nasal cannula and tubing (not supplied)
should be used to deliver oxygen from the device� The device works
with cannula tubing up to 100 ft� (30�5 m)�
6� To start the device, press the Power button� After the first press,
the display screen and the 4 button backlights turn on and you
will see a screen similar to the one shown below�
1
2
3
4
