6
English
IMPORTANT!
– The type plate is located at the
bottom of the system.
– Before connecting the AC power cord
to the wall outlet, ensure that all
other connections have been made.
– Never make or change any
connections with the power switched on.
– A separate power switch is provided
on the front of the subwoofer. Please
switch it on after completing all
connections in order to enjoy 2.1-channel
sound output.
Step 1: Placing speakers and
subwoofer
For best possible surround sound, locate your
speakers and subwoofer as follows:
●
Place the left and right speakers at equal
distances from the TV set and at an angle of
approximately 45 degrees from the listening
position.
●
Place the subwoofer on the floor near the TV.
Notes:
–
To avoid magnetic interference, do not position
the front speakers too close to your TV set.
–
Allow adequate ventilation around the DVD System.
Step 2: Connecting speakers
and subwoofer
1
Connect the supplied audio cables to DVD
player’s
LINE OUT (L/R)
jacks and the
Subwoofer’s
AUDIO IN
jack.
2
Connect the speaker wires to the
SPEAKER
terminals on the subwoofer, right speaker to "R"
and left speaker to "L", coloured (marked) wire
to "+" and black (unmarked) wire to "-".
●
Fully insert the stripped por tion of the speaker
wire into the terminal as shown.
Notes:
–
Ensure that the speaker cables are correctly
connected. Improper connections may damage
the system due to short-circuit.
–
For optimal sound performance, use the
supplied speakers.
–
Do not connect more than one speaker to any
one pair of +/- speaker terminals.
–
Do not connect speakers with an impedance
lower than the speakers supplied. Please refer
to the SPECIFICATIONS section of this manual.
Connections
pg001_pg024_MCD137_93 IFU_Eng
2008.4.24, 15:06
6
