Device Descriptions
Philips Telemonitoring Set
2-11
Pulse
Oximeter
The
Pulse Oximeter
measures blood oxygen level (%SpO
2
) and pulse
rate. It has a plastic display case with a finger-clip sensor attached to it.
The front of the case is shown in the figure below. The rear of the case
has a compartment for batteries that power the device.
Note
Two models of Pulse Oximeter are available (
M3814A
and
M3814B
).
Check your Pulse Oximeter to determine which one you have. The part
numbers are shown on the rear of the device.
Pulse
Oximeter
Display Case
LED display windows show the blood oxygen level (%SpO
2
) and pulse
rate (in beats per minute) measured from the end of your finger.
The
M3814A
has
1 display
in which
%SpO
2
and
pulse (/min.)
measurements alternate. LEDs below the display light to indicate which
measurement is being displayed.
The
M3814B
has
2 displays
, one each for
%SpO
2
and
pulse (/min.)
.
Pushing the
START
button causes the Pulse Oximeter to begin taking a
measurement.
The
Radio Test
button
. on
M3814A,
on
M3814B
-- tests
the transmission of measurements from the Pulse Oximeter to the Home
Hub or TeleStation.
The
Finger-clip sensor
is clipped on the end of one of your fingers
and measures your blood oxygen level and pulse rate.
T
START
button
One
Radio Test
button
M3814A
M3814B
Display
Two
Displays
START
STOP
Radio Test
button
Finger-clip
Sensor
button
All manuals and user guides at all-guides.com