Philips FTL13U Скачать руководство пользователя

Страница: 144 / 180

Circuit Descriptions, Abbreviation List, and IC Data Sheets

EN 144

FTL13U AA & AB

If the standard is not supported, the set changes to blue
mute via the EBILD, and a message is displayed.

10. If the standard is the same as the last status, the ADC is in

the correct state, and both FBX and EBILD are set (see
lookup table).

11. If the standard is changed, the ADC is set to the detected

standard and a new check is done. If the standard is valid
and supported, the new standard is stored in NVM as last
status.

12. The FBX and EBILD are set (see lookup table).
13. Picture is unblanked and sound demuted.

Table 9-3 I/O lookup table

9.5

Video Processing

9.5.1

Introduction

Note:

The FBX processing part is equal as described in the R8

manual. Therefore, it is not described here (except for some
basics).

The I/O peripherals are as follows: (see also figure "Block
diagram FTL13U" in paragraph "Block Diagram"):
•

Four AV inputs 1fH (AV4 can be 1fH or 2fH/3fH YPbPr), a
side IO, and a DVI 2fH/3fH input.

The video processing is based on four key functions:
•

The

HIP

+ comb filter (for simple source select and video/

chroma processing).

•

The

EBILD

takes over the video control functions of the

HOP (which is used in CRT based sets).

•

The

FBX

configuration consisting of a PICNIC (2fH

featuring), a FALCONIC (Auto TV featuring), and an
EAGLE (motion compensation and "Pixel Plus"
processing).

•

2fH/3fH

source selection.

Additionally, the following features are added
•

One-chip

3D Comb filter

: this comb filter uses spatial and

temporal filtering for the elimination of cross color and
cross luminance components. Not only for vertical lines,
but also for stationary diagonal lines.

•

The OTC does the

light sensor

measurement required for

"Active Control".

Basic functionality of HIP

I/O functionality

•

The HIP selects the signals entering on 1fH base band.
The HIP contains a source select matrix in order to handle
a Tuner, three CVBS sources, two Y/C sources, and two
RGB inputs (this in fact means one VIF input for tuner, four
CVBS inputs with among them two Y/C inputs, and two
RGB inputs). The HIP detects by itself whether the source

is Y/C or CVBS, and decides how to handle the signal for
further image processing.

•

The HIP delivers the main video output (YUV- 1fH signal)
for further image processing and three CVBS outputs,
being: CVBS PIP/DS, CVBS_TXT_OUT for comb filter
(always following YUV main!) and CC processing, and the
CVBS/Y_RECORD_OUT for AV2.

IF functionality

•

The HIP contains a multi standard IF circuit for video
demodulation with AFC (Automatic Frequency Control)
functionality, a sound IF amplifier, and an AM demodulator.
An extra group delay correction is included.

•

Chroma demodulation and video processing

•

Sync acquisition, delivering H_A/V_A (Horizontal/Vertical
Acquisition) towards FBX.

Basic functionality of EBILD

The EBILD is the interface between the FBX and the LCD
screen. Its principal functions are:
•

Video control functions of the HOP (Saturation, Contrast,
Brightness).

•

OSD insertion with blending.

•

Video Matrix (NTSC, ATSC, PAL).

•