Philips FlatTV Matchline 50FD9955, Руководство пользователя

Страница: 7 / 24

7
Connect your computer
Operation
Directly to the plasma display
&
Connect one end of a VGA cable supplied to
the video card of the computer and the other
end to the
VGA
(or to
RGB
Digital
DVI
in
case of a computer with a digital
RGB
output)
connector at the right side of the monitor. Fix
the connectors firmly with the screws on the
plug. See Table of Signals Supported, p. 19.
é
In case of a Multimedia computer, connect the
audio cable to the
AUDIO
outputs of your
computer and to the
AUDIO
inputs of an
additional audio receiver.
To an electronic receiver box
See the handbook of the receiver box.
&
Connect one end of a VGA cable to the video
card of the computer and the other end to the
VGA IN
connector at the rear side of the
receiver box. Fix the connectors firmly with the
screws on the plug.
é
In case of a Multimedia computer, connect the
audio cable to the
AUDIO
outputs of your
computer and to the
AUDIO VGA IN R
(right)
and
L
(left) inputs of the receiver box.
Note: When you connect a computer to this monitor, attach the supplied ferrite cores. If you do not do this, this
monitor will not comply with the mandatory CE or C-Tick standards.
& Set the (large) ferrite core on one end of the power cable (supplied).
é
In case of a computer with a digital RGB output set the (small) ferrite cores on both ends of the DVI
cable (not supplied).
“
Click the lids tightly until the clamps click.
‘
Use the bands to secure the ferrite cores.
R6 / AA
Power On/Off
Mains inlet
&
Insert the mains plug supplied
into the mains inlet at
the bottom of the monitor and in the wall socket. For
safety, please, only use the supplied rim-earthed mains
cord which has to be inserted in a grounded socket.
é
Remote control
: remove the cover of the battery
compartment.
In
sert the 2 batteries supplied (Type LR6/AA-1.5V).
The batteries supplied do not contain the heavy metals
mercury and cadmium. Nevertheless in many countries
batteries may not be disposed of with your household waste.
Please check on how to dispose of batteries according to
local regulations.
“
Make sure that your receiver box and/or PC are
switched on and that your PC is in the correct display
mode (see p. 19).
‘
Switch the plasma display on
:
Press the power button
B
at the bottom side of the
monitor.
A green indicator lights up and the screen comes on.
When the plasma display does not receive a supported
vga signal or is not connected to a receiver box, the
screen switches to standby and the red indicator lights
up.
Warning:The Power On/Off switch does not
disconnect the plasma display completely from the
mains.
2268.1 am 03-12-2003 09:47 Pagina 7