Philips DC1010 - annexe 2, Руководство пользователя

Страница: 13 / 14

Problem
– Possible cause
• Remedy
No sound /power
–
Volume not adjusted
• Adjust the VOLUME
–
Power cord not securely connected
• Connect the AC power cord properly
– Batteries dead/ incorrectly inserted
• Insert (fresh) batteries correctly
– CD contains non-audio files
• Press
5
,
6
once or more to skip to a CD audio
track, instead of the data file.
Display does not function properly/ No
reaction to operation of any of the con-
trols
– Electrostatic discharge
• Switch off and unplug the set. Reconnect after a
few seconds
Severe radio hum or noise
–
Electrical interference: set too close to TV, VCR or
computer
•
Increase the distance
- - indication
– No CD inserted
• Insert a CD
– CD badly scratched or dirty
• Replace/ clean CD, see Maintenance
– Laser lens steamed up
• Wait until lens has cleared
– CD-R(W) is blank or not finalized
• Use a finalized CD-R(W) or suitable CD Audio
disc only
Note:
Make sure the CD is not encoded with
Copyright protection technologies, as some
do not conform to the Compact
Disc standard
.
The CD skips tracks
–
CD damaged or dirty
• Replace or clean CD
– Program is active
• Quit program mode
Note:
A CD badly scratch or dirty may result in
improper operation
.
If a fault occurs, first check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or service centre.
WARNING:
Do not open the set as there is a risk of electric shock. Under no cir-
cumstances should you try to repair the set yourself, as this will
invalidate the guarantee.
Troubleshooting
IFU_DC1010_37_ENG 2010.5.4 9:57 Page 13