Power Supply
Remote control
Important!
• Before using the remote control, remove
the insulation plastic tab as shown
in figure
@
.
• If the remote control does not function
correctly or the operating range is
reduced, replace the battery with a new
(CR2025) type battery.
1
Pull the battery tray out as shown
in figure
@
.
2
Replace a new battery according to polarity
indication, and fully insert the battery tray
back to the original position.
•
Incorrect use of batteries can cause
elec-
trolyte leakage and will corrode the compart-
ment or cause the batteries to burst:
•
Do not mix battery types: e.g. alkaline with
carbon zinc. Only use batteries of the same
type for the set.
•
When inserting new batteries, do not try to
mix old batteries with the new ones.
• Remove the batteries if the set is not to be
used for a long time.
Batteries contain chemical substances, so
they should be disposed of properly.
Using AC power
1 Check if the power/mains voltage,
as shown
on the type plate located on the
bottom of the set
, corresponds to your
local power supply. If it does not, consult your
dealer or service center.
2
If your set is equipped with a voltage
selector, adjust the selector so that it match-
es with the local power supply.
3 Connect the power cord to the
AC~ MAINS
inlet and the wall socket.The
set is now ready for use.
4 To switch the set off completely, withdraw the
power cord from the wall socket.
5
Install the unit near the AC outlet and where
the AC power plug can be easily reached.
•
Disconnect the power cord from the wall
socket to protect your set during heavy thun-
derstorms. Children could seriously injure
themselves as the free end of the cable may
still be live if only the connector is removed
from the MAINS socket at the back of the
unit.
The type plate is located on the
bottom of the set
.
Auto power saving
•
When the source is selected to
CD
or
USB
and the set is in the PAUSE position for 5
minutes, the set will be auto switched to the
stop position to save power.
•
When the source is selected to
CD
or
USB
and the set is in the STOP position for 15
minutes, the set will auto switch off.
Helpful hints:
–
To avoid unnecessary energy consumption,
always press
POWER
on the set to power
off the set after using the set.
CAUTION
- Visible and invisible laser radiation.
If the cover is open, do not look at
the beam.
- High voltage! Do not open.You run
the risk of getting an electric shock.
The machine does not contain any
user-serviceable parts.
- Modification of the product could
result in hazardous radiation of
EMC or other unsafe operation.
IFU_AZ3830_latam_ENG 2006.11.24 11:14 Page 6
