English
POWER SUPPLY
9
BATTERIES (OPTIONAL)
For the set (optional)
1.
Open the battery compartment and insert six batteries, type
R-20
,
UM-1
or
D-cells
, (preferably alkaline) with the correct
polarity as indicated by the "+" and "-" symbols inside the
compartment.
Remote control (supplied)
Open the battery compartment and insert two batteries, type
AAA
,
R03
or
UM4
(preferably alkaline).
2.
Replace the compartment door, making sure the batteries are
firmly and correctly in place. The set is now ready to operate.
– Incorrect use of batteries can cause electrolyte leakage and
will corrode the compartment or cause the batteries to burst.
Therefore:
–
Do not mix battery types
, e.g. alkaline with carbon zinc.
Only use batteries of the same type for the set.
– When inserting new batteries, do not try to mix old
batteries with the new ones.
Important!
Remove the batteries if the set is not to be used for a
long time.
Batteries contain chemical substances, so they should be
disposed of properly.
USING THE POWER
1.
Check if the power voltage
as shown on the type plate
located on the base of the set
, corresponds to your local
power voltage. If it does not, consult your dealer or service
center.
2.
Connect the power cord to the MAINS inlet and the wall
outlet. The power supply is now connected and ready for use.
3.
To switch off completely, withdraw the power cord from the
wall outlet.
– Disconnect the power cord from the wall outlet to protect your
set during heavy thunderstorms.
GENERAL OPERATION
1.
To select sound source adjust the CD TUNER TAPE/
OFF
slider.
2.
Adjust the sound with the
VOLUME
and
DBB
(Dynamic Bass
Boost) controls.
– The display shows the volume
UoL
level briefly.
3.
To switch off the set, adjust the slider to TAPE/
OFF
position and
check that the cassette keys are released.
Note:
When the set is switched off the tuner presets will be
retained in the set’s memory.
6 x D-cells - R20 - UM1
MAINS
AZ 1025 /17
page
9
TUNER
CD
XP AZ 1025/17 19-09-2000 13:02 Pagina 9
