DIGITAL TUNER
10
MW (AM) TUNING STEP (SOME VERSIONS ONLY)
In North and South America the frequency step between adjacent
channels in the AM band is
10 KHz
. In the rest of the world this
step is
9 KHz
. Usually this frequency step has been preset in the
factory of your area.
To change the tuning step
1.
Adjust the CD TUNER TAPE/
OFF
slider to TAPE/
OFF
position.
2.
Press and hold down on BAND and SEARCH
∞
simultaneously
to select
9 KHz
.
3.
Adjust the CD TUNER TAPE/
OFF
slider to TUNER position and
then release the BAND and SEARCH
∞
controls.
™
All preset stations will be lost and need to be programmed
again.
• To select
10 KHz
, repeat steps
1-3
but use SEARCH
§
instead.
TUNING TO RADIO STATIONS
1.
Adjust the CD TUNER TAPE/
OFF
slider to TUNER position.
2.
Press BAND to select your wave band.
To tune to radio stations, press the SEARCH or TUNING
controls
∞
or
§
until the frequency in the display starts
running, then release the control.
™
Srch
appears in the display and the radio automatically
tunes to a station of sufficient reception.
3.
Repeat if necessary until you find the desired station.
•
To tune to a weak transmitter
, briefly press SEARCH
∞
or
§
until you have found optimum reception or the correct
frequency.
™
When
STEREO
appears in the display, you are receiving a FM-
stereo transmitter.
To improve radio reception
• For
FM
, pull out the telescopic antenna. Incline and turn the
antenna. Reduce its length if the signal is too strong (very
close to a transmitter).
• For
AM
, the set is provided with a built-in antenna so the
telescopic antenna is not needed. Direct the antenna by
turning the whole set.
English
AZ 1025 /17
page
10
TUNER
TUNER
FM
CD SY
NCHR
O STA
RT RE
CORD
IN
PAU
SE S
VOLUME
CD SY
NCHR
O STA
RT RE
CORD
VOLUME
SHUFFLE
FM
TUNER
REPEAT
SHUFFLE
BAND
PRESETS
PROG
AZ1025
XP AZ 1025/17 19-09-2000 13:02 Pagina 10
