13
EN
E
ngl
ish
7
Place the water tray back into the
appliance (fig
n
).
8
Place the water tank back into the
appliance (fig
r
).
Cleaning the pre-filter
Note
•
If the pre-filter is damaged, worn or
broken, do not use. Visit
www.philips.com/support or
contact the Consumer Care Center
in your country.
Filter alert light
status
Follow this
F0 displays on the
screen and wick&
pre-filter cleaning
alert
goes on
Clean the pre-
filter
1
Pull the top part of the back panel
towards you to release it from the
appliance (fig
c
).
2
To remove the pre-filter, press the
two clips down and pull the filter
towards you (fig
d
).
3
Wash the pre-filter under a running
tap. If the pre-filter is very dirty, use
a soft brush to brush away the dust
(fig
‡
).
4
Air dry the pre-filter.
Note
•
Make sure that the pre-filter is
completely dry. If it is still wet,
bacteria may multiply in it and
shorten the lifetime of the pre-filter.
5
After the pre-filter is completely dry,
place it back into the back panel
(fig
h
).
6
Touch and hold for 3 seconds to
reset the pre-filter cleaning time.
Descaling the
NanoCloud rotary
humidification wick
Filter alert light
status
Follow this
F0 displays on the
screen and wick&
pre-filter cleaning
alert
goes on
Descale the
NanoCloud
rotary
humidification
wick
1
Pull out the water tank (fig
j
).
2
Lift the water tray upwards and pull
it out horizontally (fig
k
).
3
Take the wick wheel off the wick
support (fig
†
).
4
Soak the NanoCloud rotary
humidification wick in cleansing
agent (e.g diluted white vinegar,
Citric acid solution) for two hours
(fig
ˆ
).
Note
•
Please use mid or acid cleanser
•
White vinegar (5% acetic acid)
mix with equal amount of water
•
4g citric acid with 4L water
•
If there are white deposits
(limescale) on the filter, make sure
that the side with the white deposits
is immersed in the water.
•
Do not take the NanoCloud rotary
humidification wick off the wheel
during descaling.
