Mechanical Instructions
4.
4.4.5
Power Supply Unit (PSU)
Caution:
it is mandatory to remount all different screws at their
original position during re-assembly. Failure to do so may result
in damaging the PSU.
1. Gently unplug all connectors from the PSU.
2. Remove all fixation screws from the PSU.
3. The PSU can be taken out of the set now.
4.4.6
IR board Control Unit
Refer to
,
for details.
1. Unplug the connector from the SSB.
Caution:
be careful, as these are very fragile connectors!
2. Remove all the fixation screws from the IR board control
unit [1].Refer to
3. Remove the IR lens [2], IR board [3] from the
DECO_REAR_COVER. Refer to
When defective, replace the whole unit.
Figure 4-26 IR board removal[1]
Figure 4-27 IR board removal[2]
4.4.7
Speakers
1. Gently release the tapes that secure the speaker cables.
2. Unplug the speaker connector from the SSB.
3. Take the speakers out.
When defective, replace the both units.
4.4.8
WIFI module
1. Unplug the connector from the SSB.
2. Remove fixation screw that secure the WIFI module,
getntly remove the module from the set.
When defective, replace the whole unit.
4.4.9
LCD Panel
1. Remove the SSB as described earlier.
2. Remove the PSU as described earlier.
3. Remove the keyboard control panel as described earlier.
4. Remove the stand bracket as described earlier.
5. Remove the IR Board as described earlier.
6. Remove the WIFI module as earlier.
7. Remove the fixations screws that fix the metal clamps to
the front bezel. Take out those clamps.
8. Remove all other metal parts not belonging to the panel.
9. Lift the LCD Panel from the bezel.
When defective, replace the whole unit.
19850_103.eps
1
1
1
19850_104.eps
2
3
