■
Enter the new IP address and confirm it with the ‘OK’ button.
■
If NetCam4 has a problem, you can reboot by
clicking “Reboot”.
2.4
Configuring NetCam4
■
After assigning a new IP address to the NetCam4, you
may configure the administrator’s options. Click ‘Start
Configuration’ button, and you will be connected to the Administrator
pages in the NetCam (see Chapter 4).
2.4.1
Fast Configuration
■
If you want another NetCam4 with the same setup,
you can use ‘Fast Configuration’.
■
Using the ‘Load’ button, you can use the saved
configuration of another NetCam4. However, some
information such as; ‘Serial Number’, ‘Date & Time’
and ‘IP configurations’ need to be setup independantly. You should
configure ‘Date & Time’ and ‘ IP Configuration’ again with setup program.
‘Serial Number’ cannot be changed.
To save:
After setup, close NetCam4 homepage.
■
Click ‘Save’ button.
■
Save the information (select a suitable directory and file name).
To Load:
■
Select the directory and file name of the saved NetCam 4.
■
Click the ‘open’ button and click ‘ok’ to confirm.
13
NetCam4
Section 2
NetCam_ii_99011_0047.qxd 12/13/00 1:55 PM Page 13
