EN 37
En
gl
is
h
4. Connect the USB storage device.
5. Press .
6. Select
[Setup]
>
[TV settings]
>
[Preferences]
>
[Channel list copy]
>
[Copy to TV]
, then press
OK
.
The channel list is copied to the TV storage
device.
7. Disconnect the USB storage device.
Step 3: If the second TV has no channels
installed
1. Switch on the second TV (on which you
want to copy the channel list).
2. Press .
3. Select
[Setup]
>
[Search for channels]
>
[Reinstall channels]
, then press
OK
.
The country menu is displayed.
4. Make sure that the country setting is the
same as for the first TV.
5. Press .
6. Press
[Cancel]
to exit.
7. If the country setting is different, reinstall
the second TV to match the country setting
of the first TV. See
Set up your TV >
Restore default settings
(Page 41).
8. Connect the USB storage device to the
second TV.
9. Press .
10. Select
[Setup]
>
[TV settings]
>
[Preferences]
>
[Channel list copy]
>
[Copy to TV]
, then press
OK
.
The channel list is copied to the second TV.
11. Disconnect the USB storage device.
Satellite settings
What you can do
View satellite channels
Note:
Available on certain models only.
[Search for satellite]
is only available if the
TV supports DVB-S.
To receive satellite channels, connect the
SAT connector on your TV to a satellite dish
antenna.
LNBs
This TV can receive signals from 4 different
low noise block-down converters (LNBs).
An LNB is mounted at the end pole of the
dish antenna and captures signals from a
satellite.
Install satellite channels
1. While you watch TV, press .
2. Select
[Setup]
>
[Search for satellite]
>
[Reinstall channels]
.
3. Follow the onscreen instructions to
complete the installation.
4. Once complete, select
[Finish]
, then press
OK
.
Select connection type
While you install satellite channels, you need
to set the connection type. The connection
type determines the number of LNBs on
your dish antenna and the number of
satellite channels you can install.
1. After you select
[Reinstall channels]
,
select
[Settings]
and then press
OK
.
2. Select
[Connection type]
.
3. Select a setting, then press
OK
.
[One LNB]
: Select if you have only one
LNB.
[DiSeqC Mini (2 LNBs)]
: Select if you
have 2 LNBs.
[DiSeqC 1.0 (3-4 LNBs)]
: Select for 3
or 4 LNBs.
