06-10-2020 15
:
11
Pagina 1 van 9
http://manual.zwave.eu/backend/make.php?lang=en&sku=PHI_PST02-1C
Philio Tech
Z-Wave 3 in 1 Sensor (Door /
Window, Illumination, Temperature)
SKU: PHI_PST02-1C
Quickstart
This is a
secure Alarm Sensor
for
Europe
. To run this device please insert fresh
1 * CR123A
batteries. Please make sure the internal battery is fully ch
To add this device to your network execute the following action:
1. Have Z-Wave Controller entered inclusion mode.
2. Pressing tamper key three times within 1.5 seconds to enter the inclusion mode.
3. After add successful, the device will wake to receive the setting command from Z-Wave Controller about 20 seconds.
Important safety information
Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law. The manufacturer, import
distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material. Use
equipment only for its intended purpose. Follow the disposal instructions. Do not dispose of electronic equipment or batteries in a fire or near open heat sou
What is Z-Wave?
Z-Wave is the international wireless protocol for communication in the Smart Home. This device is suited for use in the region mentioned in the Quickstart se
Z-Wave ensures a reliable communication by reconfirming every message (
two-way communication
) and
every mains powered node can act as a repeater for other nodes (
meshed network
) in case the receiver is not
in direct wireless range of the transmitter.
This device and every other certified Z-Wave device can be
used together with any other certified Z-Wave
device regardless of brand and origin
as long as both are suited for the same frequency range.
If a device supports
secure communication
it will communicate with other devices secure as long as this
device provides the same or a higher level of security. Otherwise it will automatically turn into a lower level of
security to maintain backward compatibility.
For more information about Z-Wave technology, devices, white papers etc. please refer to www.z-wave.info.
Product Description
With the 3-in-1 Sensor PST02-1C by Philio you can not only monitor your door’s and window’s status, because the device is equipped with 3 different senso
Door/Window Sensor
Temperature Sensor
Light Sensor
The sensor consists of two parts: a detector and a magnet. The Magnet should be mounted on the door’s/window’s opening part and the detector on the fixe
Opening the door/window will remove the magnetic field, trigger the detector and generate an alarm condition, (if the system is armed).
The sensor can also be used for automatic light control, one possible scene is to get the illumination lux level from built-in light sensors and send a signal to
control center to turn the light on once the door will be opened when the room is dark. Every time, when the door/window sensor triggers a status change, it
