Installation Steps
1. Connect to the power supply, please use the USB-C cable.
The other end uses the USB-A provided by the TV or the
adapter.
2. Refer to IR Learning. Learn IR Code.
3. Install the device on the upper edge of the TV.
4. Refer to Adjustment mode. Adjust the detection range of the
device.
5. Short press the button on the top of the device. The device
enters operation mode and confirms that the device is working
properly.
For Instruction to http:// www.philio-tech.com
「
IR Learning
PAR02 only support
NEC protocol, which specifies a carrier
frequency of 38 kHz.
The IR Learning can be used for learning
one control code of the IR Remote Controller, and storing the
code.
When powered for the first time, the device’s red LED light will
flash on and off alternately at 250 microsecond intervals. This
means device haven't learned the IR code.
Step 1. Press the button on the left back of the device twice in 2
second. Then green LED Light will flash at 1 second
intervals and red LED light will off.
Step 2. Use the remote control to press the power button to learn
IR code. If IR learning completed, the device’s green LED
light will fast flash twice.
Notice:
If IR learning failed, the device’s will return to previous
status. Repeat step1 to Learn IR Code.
If you need to change TV, follow the next steps to clear the IR
code.
Step 1. Make sure device in stanby
mode. Red LED light will on.
Step 2. Press the button on the left back of the device three times
in 3 second. And hold on the button press without
releasing. Then red LED light will flash on and off
alternately at 250 microsecond intervals.
Step 3. Press the button on the left back of the device twice in 2
second. Then green LED light will flash at 1 second
intervals and red LED light will off.
Step 4. Use the remote control to press the button to learn IR
code. If IR learning completed, the device’s green LED
light will fast flash twice.
2
