1
In Wall Micro Switch PAN33
Introduction
This product can be operated in any Z-Wave network with other Z-Wave certified
devices from other manufacturers. All mains operated nodes within the network will
act as repeaters regardless of vendor to increase reliability of the network. Mini size
design let the module can easily hide itself into the wall box and that will be good
for the house decoration.
There are many kind of application by using the module to switch Load On and Off,
one main application is the light control. The new smart relay calibration technology
can reduce the inrush current caused by the load and let the module work perfectly
with many kind of light like incandescent, fluorescent and LED light.
Safety Precautions and Installation
Avoid installing the unit in storming or raining weather.
Be sure to isolate or switch off power source before installing or maintenance.
Do ensure that the power supply circuit protected by a 16A circuit breaker or
suitable equivalent fuse.
IMPORTANT
Installation must be performed by skilled technicians who are informed about
the standards and technical requirements of the appliance and its proper
installation.
Check your local codes as they apply to your situation. If the house wiring is
of aluminum, consult with an electrician about proper wiring methods.
Before proceeding with the installation, TURN OFF THE POWER TO THE
LIGHTING CIRCUIT AT THE CIRCUIT BREAKER OR FUSE BOX TO AVOID
ELECTRICAL SHOCK.
Specification
Operating Voltage
100 -240VAC 50Hz-60Hz
Maximum Load
Max.
6.5A
(230Vac/120Vac) (Riesistive load)
Range
Minimum
40m indoor
100m outdoor line of sight
Operating Temperature
0°C
to
40°C
Humidity
Up to 85% max.
Storage Temperature
-20°C to 60°C
Location
Indoor use only
Frequency Range
868.40MHz; 869.85MHz (EU)
908.40MHz; 916.00MHz (USA/Canada)
920.90 MHz, 921.70 MHz, 923.10 MHz (Taiwan)
RF Maximum Power
+10dBm (Peak), -10dBm (Average)
OTA
Support
FCC ID
RHHPAN33
Dimensions
47.5 x 39 x15.6 mm
Wire
0.75mm², 18AWG
** Specifications are subject to change and improvement without notice.
Troubleshooting
Symptom
Cause of Failure
Recommendation
The Switch not working and
LED off
1.
The Switch is not connect
to the Main power
2.
The Switch break down
1.
Check power connections
2. Don’t open up the Switch and
send it for repair.
The Switch LED
Check if the load connect
Set the ON/OFF switch of the
