5
state
2 : Switch on
3
Manual On/Off
mode
1
0-1
1
0
：
Disable
manual On/Off
1
：
Enable
manual On/Off
4
LED indication
mode
1
1-3
1
1
：
Show switch
state
2
：
Show night
mode
3 : One flash
mode
5
Manual Switch
Report mode
1
0-1
1
0 : Disable
1 : Enable
3-1
External switch mode
Manual switch S1 and S2 can set to Edge mode or Pulse mode or Edge-Toggle
mode, default value is Edge mode.
Edge mode: this mode is suitable for the
bi-stable
wall switch that has indicator
point on the switch, and the same position correspond to same state of relay1. If
the PAN33 relay change the state because of receiving Z-Wave RF command, it
may need two times of change (switch on to off or switch off to on) to let relay back
to the correspond state.
Pulse mode: this mode is suitable for the toggle type wall switch to swap the state
of Relay1.
Edge-Toggle mode: this mode is suitable for the normal bi-stable switch, every
time when change the state of the wall switch will also swap the state of Relay1.
3-2 Restore switch state mode
Whenever the AC power return from lost, PAN33 will restore the switch state which
could be SWITCH OFF
、
LAST SWITCH STATE
、
SWITCH ON. The default setting is
LAST SWITCH STATE.
3-3 Manual On/Off Mode
：
：
：
：
The On/Off function of S1
、
S2 and learn switch can be disabled or enabled by this
parameter, default value is Enable. But the learning operation won’t be affected.
When manual On/Off function is disabled, the RF command can only switch On but
not Off. This is useful function for keeping the device in switch on state.
3-4 LED indication Mode:
3-4-1 Show switch state
：
LED on for switch on and off for switch off. The default
value is Show switch state.
3-4-2 Show night mode
：
LED off for switch on and on for switch off.
3-4-3 One Flash mode
：
When the state of switch changes, LED will be on only
one second, then LED keeps off.
3-5 Manual Switch Report mode :
Whenever PAN32 is manually switch on or off, it will send BINARY_SWITCH_
REPORT to the node of group1. The default setting is Enable the function.
5. Firmware update over the air (OTA)
PAN33 is based on 700 series SoC and supports Firmware Update Command
Class, it can receives the updated firmware image sent by controller via the Z-wave
RF media. It is a helpful and convenient way to improve some function if needed.
6. Command Classes
The Switch supports Command Classes including…
Command Class
Version
Required Security Class
Z-Wave Plus Info
2
None
Security 0
1
None
Security 2
1
None
