Philco PDP 4 WH, Руководство пользователя

Страница: 13 / 36

EN - 11
03/2015 Copyright © 2015, Fast ČR, a. s.
Warning
Connection to the water and electricity supplies should only be performed by a qualifi ed technician.
The dishwasher should not stand on top of the water hoses or the electricity supply cable
The appliance must be connected to the water supply network using new piping. Do not use old piping.
Water supply hose
Connect the cold water supply hose to a threaded 3/4(inch) connector and make sure that it is fastened tightly
in place. If the water pipes are new or have not been used for an extended period of time, let the water run to
make sure that the water is clear and free of impurities. If this precaution is not taken, there is a risk that the
water inlet can get blocked and the appliance could be damaged.
Drain hose
Fit the drainage hose of your machine to the drainage pipe without bending. If the length of the hose is not
suffi
cient, apply to the authorized service. Remember that the length of the hose should not exceed 4meters
even when with an extension. If the drainage hose is longer the 4 m. the dishes will not be cleaned properly
secure your hose fi rmly to the drainage pipe to avoid it coming off during the washing process.
If the sink is 1000mm higher from the fl oor, the excess water in hoses cannot be drained directly into the sink.
It will be necessary to drain excess water from hoses into a bowl or a suitable container that is held outside and
lower than the sink.
The waste connection must be at a height of between 50cm (minimum) and 100cm (maximum) from the
bottom of the dish.
M
ax
100
0m
m
M
in4
00
mm
m
in120m
m
min 40mm