Philco PD 1045 EA, Руководство пользователя

Страница: 15 / 130

Copyright © 2020, Fast ČR, a. s. Revision 12/2021
EN - 13
Detergent usage
Only use detergents specifically designed for
domestic dishwashers. Keep your detergents in cool,
dry places out of reach of children.
Add the proper detergent for the selected program
to ensure the best performance.
The amount of detergent needed depends on the
cycle, load size, and soil level of dishes.
Do not fill detergent into the detergent compartment
more than required; otherwise you can see whitish
streaks or bluish layers on glass and dishes and may
cause glass corrosion. Continued use of too much
detergent may cause machine damage.
Using little detergent can result in poor cleaning and
you can see whitish streaksin hard water.
See the detergent manufacturer’s instructions for a
further information.
Filling the detergent
Push the latch to open the dispenser and pour in the
detergent.
Close the lid and press it until it locks in place. The
dispenser should be refilled just before the start of
each programme. If the dishes are heavily soiled,
place additional detergent in the pre-wash detergent
chamber.
Using combined detergents
These products should be used according to the
manufacturer’s instructions.
Never put combined detergents into the interior
section or the cutlery basket.
Combined detergents contain not only the detergent
but also rinse-aid, salt replacement substances
and additional components depending on the
combination.
We recommend you do not use combined
detergents in short programmes.
Please use powder detergents in such programmes.
If you encounter problems when using combined
detergents, please contact the detergent
manufacturer.
When you stop using combined detergents, make
sure that water hardness and rinse aid settings are
set to the correct level.
Rinse-aid usage
The rinse aid helps to dry the dishes without streaks
and stains. Rinse-aid is required for stain-free utensils
and clear glasses. The rinse aid is automatically
released during the hot rinse phase. If rinse aid
dosage setting set too low, whitish stains remains on
dishes and dishes do not dry and washed clean.
If rinse aid dosage setting set too height, you can see
bluish layers on glass and dishes.
Filling the rinse-aid and setting
To fill the rinse aid compartment, open the rinse-aid
compartment cap. Fill the compartment with rinse
aid to the MAX level and then close the cap. Be
careful not to overfill the rinse aid compartment and
wipe up any spills.
In order to change the rinse aid level, follow the
below steps before turning on the machine:
• Turn on the machine by pressing the On/Off
button.
• Press the Up button for at least 5 seconds
immediately after the machine is turned on.
• Release the Up button when all leds blinks twice.
The last setting level is displayed.
• Press Up or Down button to increase or decrease
the hardness level.
• Turn off the machine to save the setting.
The factory setting is “4”.
If the dishes are not drying properly or are spotted,
increase the level. If blue stains form on your dishes,
decrease the level.