150Mbps Wireless N ADSL2/2+ Modem Router
www.phicomm.com
26
Chapter 4: Software Configuration
Channel:
Select the channel you want to use from the drop-down List of channel. This field
determines which operating frequency will be used. It is not necessary to change the wireless
channel unless you notice interference problems with another nearby access point.
Beacon Interval: Enter a value between 20-1000 milliseconds. The Beacon Interval value
indicates the frequency interval of the beacon. A beacon is a packet broadcast by the Router to
synchronize the wireless network. The default value is 100.
RTS/CTS Threshold: Should you encounter inconsistent data flow, only minor reduction of the
default value 2347 is recommended. If a network packet is smaller than the preset RTS threshold
size, the RTS/CTS mechanism will not be enabled. The Router sends Request to Send (RTS)
frames to a particular receiving station and negotiates the sending of a data frame. After
receiving an RTS, the wireless station responds with a Clear to Send (CTS) frame to acknowledge
the right to begin transmission. In most cases, keep its default value of 2347.
Fragmentation Threshold:
The threshold (number of bytes) for the fragmentation boundary for
directed messages. It is the maximum data fragment size that can be sent. Enter a value
between 256 and 2432
DTIM: This value, between 1 and 255, indicates the interval of the Delivery Traffic Indication
Message.
Wireless mode: In the drop-down list you can select the wireless mode. For example: 802.11
b+g+n allow 802.11b/802.11g and 802.11n wireless clients to connect to this Wireless Modem
Router.
Channel Bandwidth: Select the Bandwidth you want to use from the drop-down List. If bigger
bandwidth is selected, device could transmit and receive data with higher speed.
Guard Interval: You can leave it as AUTO.
MCS: leave it as AUTO.
