2. It is optional to replace the foot gliders (H) with casters (BB) and casters
with locking device (CC).
a. Remove the foot glider (H) from the base (E), then install the two
casters (BB) and two casters with locking device (CC) with the base,
installation procedures are same as step 1.
b. Make sure the locking device on the casters (CC) are pressed down
after installation, so that the heater will not move in any way (See
Figure 3).
ASSEMBLY INSTRUCTIONS
Hardware Used
Figure 2
Figure 4
Ground fixer X 4
Bolts (M6 X 5) x 8
1. Side place the product base (E) on a non-abrasive flat surface to prevent
scratching, unscrew the foot gliders (H) and remove from the base (E). Line
up the hole on the ground fixer (DD) with the corresponding holes on the
base (E), then insert the bolt on foot glider (H) into the holes and hand
tighten them clockwise.
To prevent heater from strong wind or incline ground, anchor the base
securely to the ground with long nails or screws (See Figure 2).
3. Insert the four narrow glass (D) into the "L" clips which have been
welded together with table top, then attach them with bolts (AA) using the
Phillips screwdriver(See Figure 4).
DD
BB
D
E
Phillips
screwdriver
E
DD
Hardware Used
Hardware Used
Caster X 2
Caster with locking device X 2
BB
AA
CC
Ground fixer X 4
DD
Figure 3
DD
H
E
CC
NOTE:
Long nails or screws are not included.
NOTE:
DO NOT tighten the bolts completely.
NOTE:
The two casters (BB) are installed on two adjacent holes
on the product base (E), so are the two casters with
locking device (CC).
9
LIFE GETS BETTER WITH PHI VILLA
