Phcbi MDF-U443, Руководство по эксплуатации

Страница: 12 / 40

10
FREEZER COMPONENTS
1. Door: To open the door, grip the handle.
2. Door gasket: This provides a tight door
seal and prevents cold air leakage. Keep
clean.
3. Inner door: Transparent acrylic plate
minimizes cold air leakage.
4. Lock:
Turn counterclockwise to 180 o
with a key and the door is securely locked.
5. Space for temperature recorder:
Refer
to page 38 for installation.
6. Evaporating tray: Defrost water from the
evaporator accumulates on the tray and
evaporates into the atmosphere. See page
24 for cleaning.
7. Control panel: See page 11 for the
details.
8. Leveling foot:
These are screw bolts
used to install and fix the unit. Adjust the
height of the leveling feet by turning the
screw bolts until 2 front casters are away
from the floor. See page 13.
9. Caster: Four casters are provided to
facilitate moving of the cabinet.
10. Condenser filter (inside): Clean a
clogged condenser filter. See page 25 for the
details.
11. Latch:
This firmly latches the door to
the freezer frame and prevents cold air
leakage.
12. Shelf: Shelf location can be freely
13. Access port (left side, rear side): This is
used for leading the measuring cable from the
chamber to the outside.
14. Fixture (rear side):
15. Lamp: Lights up when door is open.
16. Circulating fan (inside): Sucks in cold air
that has been circulating in the chamber and
sends it out for further circulation after
re-cooling it.
17. Door switch: Stops the circulating fan
when the door is open to prevent cold air
leakage. Also activates the door lamp.
18. Communication box cover:
19. Remote alarm terminal: This is used to
notice an alarm condition of the unit to remote
location. Refer to page 22 “Remote alarm
terminal”.
20. Battery switch ( ):
This is a switch for
power failure alarm. Be sure to turn off this
switch to save the battery if the freezer is not in
operation for long period. After installation,
turn on the power switch and battery switch.
21. Sub-heater switch:
Normally, turn this
switch ON. Refer to page 21.
22. Power switch:
This is for turning ON/OFF
the power to the unit. ON – “I” OFF – “
○
”
The switch is covered by a switch cover to
prevent the accidental push. To turn on or off
the switch, remove the switch cover by
loosening the screw.
adjusted to match size of stored items.