7
EN
4. Trimmer
If required, excess material can be trimmed
from around the laminated item after lamination
and cooling.
Detach the built-in trimmer
7
from the
bottom of the machine (s. Fig. A).
Trim excess material as required.
Return the trimmer to its designated
location on the bottom of the laminating
machine.
5. Corner Cutter
The built-in corner cutter
8
can be used to
trim the corners of a laminated item after
lamination and cooling.
Remove the built-in corner cutter from
the bottom of the machine (s. Fig. A).
Insert the corner of the laminated item
into the silver slot (s. Fig. B).
Press cutter down to trim the corner and
repeat with other corners as required.
Return the corner cutter, face down, to
its designated location on the bottom of
the laminating machine.
The waste container of the corner cutter
can be emptied as required. Peel open
the plastic rear cover of the corner cutter,
empty the trimmings and replace the
plastic cover. Return the corner cutter,
face down, to its designated location on
the bottom of the laminating machine.
Lamination Tips
Before laminating valuable items, do a
test using an item of similar size and
thickness.
For best results use Pfeiffer 3 Mil – 5 Mil
or 75 Mic to 125 Mic Laminating Pouches.
The laminating pouches included with this
laminator are intended for hot lamination
only.
When laminating heat-sensitive documents,
such as tickets and ultrasounds, only use
self-adhesive pouches on a cold lamination
setting.
uLam_2.2_Laminator_content_EU.indd 7
20.06.16 11:55
