Pfeiffer Vacuum OKTA 1000, Руководство по эксплуатации

Страница: 22 / 52

1
Fig. 5: Filling sealing oil for radial shaft seal rings
1 Oiler
Procedure
1. Open the filler flap on the oiler.
2. Fill the oiler with lubricant to max. halfway.
3. Close the filler flap.
4. Always make sure that the lubricator is screwed tightly to the vacuum pump.
5.4 Connecting vacuum side
WARNING
Risk of crushing from rotating parts
Fingers and hands may be caught by rotating pistons within the connection flange. This results in se-
vere injuries.
► Keep limbs out of the reach of the roots pump.
NOTICE
Property damage from intake of solid particles
During commissioning, there is a risk of damage to the suction chamber from dirt from the system or
the pipes.
► Use a suitable protective strainer ("start-up strainer") in the intake flange.
► Ensure that this strainer is only removed when the risk of solid particles entering the vacuum
pump can be excluded.
– Observe any pumping speed decrease.
Required tools
● Ring spanner,
WAF 13 with flange DN 100 ISO-F
● Ring spanner, WAF 24 with flange DN 100 PN16
Procedure
1. Degrease the connection flange.
2. Clear welded lines of any tinder, loose parts or similar before installation.
3. Route the piping between the vacuum pump and vacuum chamber so that it remains as short as
possible; at a minimum, the nominal diameter of the pump flange.
4. Select a larger nominal diameter for pipe lengths > 5 m.
5. Support or suspend the piping to the vacuum pump so that no piping system forces act on the
vacuum pump.
– Install a bellows in the piping if necessary.
6. Always use all prescribed screws to fasten the flange.
Installation
22/52